So I think the firmware update has broken something. The router is set just like it was before I did the firmware update, in which I case I went through these exact same steps and it connected fine. ' for awhile, then scannning., then same screen as before: Same steps as above, but choosing 'WCCG Secure' for the network, Store, provide password, StoreĬomres back to main screen, saying 'joining. SO - I change to a different (password protected) network: This will link the two channels as a stereo pair. Engage USB for Channels 1 and 2 using the Numbered buttons above each channel. Press the USB button on the left side of the StudioLive. So I go back to main screen, Recall to scan again, and choose it over again. By default, Windows and Mac will return Audio to channels 1 and 2 on the StudioLive. Password: (I clear this out by pressing Recall to reset, because there's no pass on this network) for example I did this on the console:Ĭonnected To: Ethernet (no Ethernet cable connected to console, though) There is strange behavior on the wifi menu. I actually tried rebooting the router completely, having my laptop connected to it (not sure if this should matter - but did it), and then booted the S元2.4.2AI.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |